澳门新葡亰赌全部网址

全国服务热线:15953195999
产品中心
您所在的位置:首页-新闻中心-新闻动态-预防电动叉车电路线束烧毁的措施!

预防电动叉车电路线束烧毁的措施!

来源:新葡亰 日期:2019-12-24 发布人:admin

  电动叉车,顾名思义是由蓄电池为主导核心控制器的叉车!除此以外,为了赋予电动叉车有更多的功能,而实现这些功能,往往需要更多的线束来控制。那么,一旦电动叉车长时间工作或预见高温天气,预防电动叉车电路线束烧毁的措施,你就很有必要知道!

  Electric forklift, as the name implies, is a forklift with battery as the leading core controller! In addition, in order to give electric forklift more functions, and to achieve these functions, often need more harness to control. Then, once the electric forklift works for a long time or foresees the high temperature weather, it is necessary to know the measures to prevent the electric forklift circuit harness from burning!
  1、使用中经常发现有的电动叉车上的线路较乱,多余导线、外露线头较多,随意乱接电线的现象也比较普遍。由此导致全车线路混乱,常会引起人为电路故障,很难查找,严重时会发生搭铁短路,烧毁电气设备和线束,引起火灾事故,直接影响到叉车的安全操作运行。
  1. In use, it is often found that the lines on some electric forklifts are disorderly, there are many redundant wires and exposed wires, and the phenomenon of randomly connecting wires is also common. As a result, the line of the whole vehicle is disordered, which often causes artificial circuit fault, which is difficult to find. In serious cases, there will be short circuit to ground, burning electrical equipment and wiring harness, causing fire accidents and directly affecting the safe operation of forklift.
  2、在维修叉车电路线束时,必须遵守修理规范,按照叉车低压线路的线色、代号及编号布置的标准布线,绝不能在故障尚末排除时就另行接电源线,或某一线段损坏时,不管颜色,不论粗细,就随意地换线,这样会人为造成整车的电路线束混乱、故障增多的后果。更换熔丝前,应该关掉所有电气设备及点火开关,并按规定进行更换。
  2. In the maintenance of forklift circuit harness, it is necessary to observe the repair specifications, follow the standard wiring arrangement of line color, code and number of low-voltage line of forklift, never connect the power line separately when the fault has not been eliminated, or change the line arbitrarily when a line section is damaged, no matter the color or thickness, which will cause the confusion of circuit harness of the whole vehicle and the consequence of more faults. Before replacing fuse, all electrical equipment and ignition switch shall be turned off and replaced as required.
澳门二手叉车
  3、若更换后的熔线又被烧断,则说明系统有短路现象,应该仔细检查并排除故障后再给予更换。有电源总开关的叉车,停车熄火后,应该关闭电源总开关。定期对线路总熔断器进行检查、养护和调整,必要时更换新的零配件。
  3. If the replaced fuse is burnt out again, it means that the system is short circuited, and it should be replaced after careful inspection and troubleshooting. For forklift trucks with main power switch, the main power switch shall be turned off after shutdown. Check, maintain and adjust the main fuse regularly, and replace new parts if necessary.
  电动叉车电路故障多半比较隐蔽,且多由导线引起,常见线路烧损多由叉车电源线短路搭铁,其电源线路未使用短路过载保护装置引起的。预付叉车电路线束烧毁的措施,你get到了吗?
  Most of the circuit faults of electric forklift are hidden, and most of them are caused by wires. Most of the common circuit burns are caused by the short-circuit grounding of forklift power line, which is not caused by the use of short-circuit overload protection device. Did you get the measure of burning down the electric harness of prepaid forklift truck?

版权所有 ? 2018澳门新葡亰赌有限公司 All Rights Reserved
地址:山东省澳门市章丘区龙山街道办事处东3公里路北韩工叉车澳门4S店   电话:15953195999
网站:/   备案号:鲁ICP备14018186号-1  技术支持:澳门诺商

 

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】

澳门新葡亰赌全部网址-新葡亰欢迎您!